LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Tail/Turn Signal Lamp Replacement (SUT) >> Installation Procedure

Installation Procedure

    Fig 1: View Of Sockets
    GM1453831Courtesy of GENERAL MOTORS CORP.
  1. Install the bulbs into the sockets (3).
  2. Position each socket into the lamp (1) and rotate 1/8 turn in order to secure.
    3. Fig 2: LR Lamp Assembly
    GM1453830Courtesy of GENERAL MOTORS CORP.
  3. Position the lamp housing (1) to the rear body opening.
    4. IMPORTANT: The outboard edge of the lamp housing will need to be positioned first.
  4. Connect the lamp housing electrical connector to the main body wire harness connector.
  5. Ensure all electrical wiring is positioned away from the sharp sheet metal flanges.
  6. Secure the inboard side of the lamp (1) to the endgate opening.
    7. NOTE: Refer to Fastener Notice .
  7. Install the screws (2).

    Tighten:  Tighten the screws to 6 N.m (53 lb in).

    8. Fig 3: Endgate Support Cable
    GM1486510Courtesy of GENERAL MOTORS CORP.
  8. Re-secure either the right or left side endgate cable to the body side bolt after lamp installation.
  9. Close the endgate.
  10. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals