LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Tail Lamp Guard Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Tubular Tail Lamp Guard
    GM855708Courtesy of GENERAL MOTORS CORP.
  1. Position the tail lamp guard to the vehicle.
    2. Fig 2: Tubular Tail Lamp Guard Screws
    GM855707Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Install the screws retaining the tail lamp guard.

    Tighten:  Tighten to 6 N.m (53 lb in).

  3. Clean the surface where the adhesive strip will mount with varnish and makers (VMP) naptha.
    4. Fig 3: Adhesive Strip To Body
    GM855709Courtesy of GENERAL MOTORS CORP.
  4. Carefully align adhesive strip to body and pull exposed tape lead down.
  5. Apply approximately 30 psi to tail lamp guard to adhere guard to the body.
  6. Close the liftgate.
scientia non olet · About LEMON Manuals