LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Rear License Lamp Replacement (SUT) >> Removal Procedure

Removal Procedure

  1. Open the spare tire carrier.
    2. Fig 1: Hand Nut & Spare Tire Carrier Frame
    GM1427918Courtesy of GENERAL MOTORS CORP.
  2. Remove the hand nut (1) securing the license plate spare wheel cover to the spare tire carrier frame (2).
    3. Fig 2: Spare Tire Carrier Frame & License Plate Pocket
    GM1453826Courtesy of GENERAL MOTORS CORP.
  3. Remove the license plate spare wheel cover (3) from the tire carrier frame (2).
    4. Fig 3: License Plate Lamp
    GM1428010Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 screws (1) securing the license plate lamp (2) to the spare tire carrier frame.
    5. Fig 4: Electrical Connector & Lamp Socket
    GM1427915Courtesy of GENERAL MOTORS CORP.
  5. Invert the lamp socket as shown.
  6. Disconnect the electrical connector from the lamp socket.
    7. Fig 5: Exploded View Of License Plate Lamp
    GM1477815Courtesy of GENERAL MOTORS CORP.
  7. Remove the lamp socket (4).
  8. Remove the bulb (2), if needed.
scientia non olet · About LEMON Manuals