LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Rear License Lamp Replacement (SUT) >> Installation Procedure

Installation Procedure

    Fig 1: Exploded View Of License Plate Lamp
    GM1477815Courtesy of GENERAL MOTORS CORP.
  1. Install the bulb (2) to the socket (4).
  2. Install the bulb socket to the lamp lens (1).
    3. Fig 2: Electrical Connector & Lamp Socket
    GM1427915Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector to the lamp socket.
  4. Position the lamp socket to the spare tire carrier frame.
  5. Ensure the retention clips are not damaged. Replace the retention clips, if damaged.
    6. Fig 3: License Plate Lamp
    GM1428010Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  6. Install the screws (1).

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

    7. Fig 4: Spare Tire Carrier Frame & License Plate Pocket
    GM1453826Courtesy of GENERAL MOTORS CORP.
  7. Install the license plate spare wheel cover (3) to the spare tire carrier frame (2).
    8. Fig 5: Hand Nut & Spare Tire Carrier Frame
    GM1427918Courtesy of GENERAL MOTORS CORP.
  8. Secure the hand nut (1) to the spare wheel cover bolt.
  9. Latch and secure the spare tire carrier.
scientia non olet · About LEMON Manuals