LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Parking and Turn Signal Lamp Replacement (SUV) >> Installation Procedure

Installation Procedure

  1. Install the bulb.
    2. Fig 1: Retaining Nuts & Connecting Electrical Connector
    GM1467132Courtesy of GENERAL MOTORS CORP.
  2. Install the bulb socket (6) by turning the socket clockwise.
  3. Install the lamp.
  4. Open the hood.
    5. NOTE: Refer to Fastener Notice .
  5. Install the retaining nuts (2).

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  6. Connect the electrical harness.
  7. Close the hood.
  8. Install the grille. Refer to Grille Replacement .
scientia non olet · About LEMON Manuals