LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Parking and Turn Signal Lamp Replacement (SUT Rear) >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing Lamp Bulb
    GM1428252Courtesy of GENERAL MOTORS CORP.
  1. Release the lamp socket (1) from the lens.
  2. From the exterior side of the end cap, insert a flat blade at the top side center of the lens.
  3. Gently pry upward on the flat blade in order to release the clip (2).
  4. Pull the top of the lens outward.
  5. Lift the lens from the opening.
scientia non olet · About LEMON Manuals