LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Identification Lamp Replacement (SUT Rear Header) >> Installation Procedure

Installation Procedure

  1. Install the bulb into the socket.
  2. Rotate the bulb socket clockwise into the lamp housing in order to secure.
  3. Connect the electrical connector to the socket.
  4. Position the lamp to the rear header opening.
  5. Ensure the foam gasket is not damaged and is in place.
  6. With light pressure, push downward on the lamp in order to secure the retention clip into the rear roof header.
  7. Remove the 2 layers of masking tape.
scientia non olet · About LEMON Manuals