LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Identification Lamp Replacement (SUT Front Header) >> Installation Procedure

Installation Procedure

  1. Install the bulb into the socket.
    2. Fig 1: Identification Lamp Assembly
    GM803120Courtesy of GENERAL MOTORS CORP.
  2. Turn the bulb socket clockwise in order to lock the socket into the lamp assembly.
  3. Install the lamp assembly to the vehicle.
  4. Connect the electrical connector.
  5. Ensure the foam gasket is in place and is note damaged. Replace the foam gasket, if damaged.
  6. Tilt the lamp forward to engage the hook.
  7. Apply light pressure downward on the lamp in order to engage the retention clip.
  8. Remove the 2 layers of masking tape.
scientia non olet · About LEMON Manuals