LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> High Mount Stop Lamp Replacement (SUV) >> Installation Procedure

Installation Procedure

  1. Install the lamp, with the attached harness, to the vehicle.
    2. Fig 1: High Mounted Stop Lamp & Harness (SUV)
    GM803121Courtesy of GENERAL MOTORS CORP.
  2. Install the grommet to the liftgate.
    3. NOTE: Refer to Fastener Notice .
  3. Install the retaining screws.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  4. Connect the electrical connector to the high mounted stop lamp.
  5. Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement (SUV) .
scientia non olet · About LEMON Manuals