LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> High Mount Stop Lamp Replacement (SUT) >> Removal Procedure

Removal Procedure

    Fig 1: Center High Mounted Stop Lamp
    GM1477816Courtesy of GENERAL MOTORS CORP.
  1. Carefully lower the rear headliner in order to access the electrical connector.
  2. Disconnect the electrical connector from the center high mounted stop lamp (CHMSL).
  3. Remove the 2 screws securing the CHMSL to the exterior rear header garnish molding.
  4. Disconnect the electrical harness grommet from the rear header.
  5. Remove the CHMSL and attached electrical harness.
  6. Remove the foam gasket and discard if damaged.
scientia non olet · About LEMON Manuals