LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> High Mount Stop Lamp Replacement (SUT) >> Installation Procedure

Installation Procedure

    Fig 1: Center High Mounted Stop Lamp
    GM1477816Courtesy of GENERAL MOTORS CORP.
  1. Install a new foam gasket.
  2. Install the lamp, with the attached harness, to the rear header.
  3. Secure the electrical harness grommet to the rear header.
    4. NOTE: Refer to Fastener Notice .
  4. Install the retaining screws.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

  5. Connect the electrical connector for the CHMSL to the headliner harness.
  6. Re-secure the rear of the headliner.
scientia non olet · About LEMON Manuals