LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Daytime Running Lamp Replacement >> Installation Procedure

Installation Procedure

  1. Install the bulb.
  2. Install the bulb socket by turning the socket clockwise.
  3. Install the lamp assembly.
  4. Engage the clips retaining the lamp.
    5. Fig 1: Daytime Running Lamp
    GM802876Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the nuts to the rear of the lamp assembly.

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  6. Connect the electrical connector.
scientia non olet · About LEMON Manuals