LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Repair Instructions >> Clearance Lamp Replacement (SUT Front) >> Installation Procedure

Installation Procedure

    Fig 1: Clearance Lamp Screw
    GM803118Courtesy of GENERAL MOTORS CORP.
  1. Install the bulb to the socket.
  2. Install the lamp housing to the vehicle. The front edge must be secure.
  3. Ensure the lamp housing foam seal is not damaged.
  4. Install the lamp assembly to the roof luggage carrier side rail end cap.
    5. NOTE: Refer to Fastener Notice .
  5. Install the screw to the lamp assembly.

    Tighten:  Tighten the screw to 2.5 N.m (22 lb in).

scientia non olet · About LEMON Manuals