LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Diagnostic Information and Procedures >> DTC B3445 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the affected stop lamp.
  2. Test for less than 1.0 ohm of resistance between the ground circuit terminal A and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Connect a test lamp between the stop lamp control circuit terminal D and the ground circuit terminal A.
  4. Ignition ON, press and release the brake pedal. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance.
  5. If all circuits test normal, test or replace the affected stop lamp.
scientia non olet · About LEMON Manuals