LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting >> Diagnostic Information and Procedures >> DTC B2625 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the affected component.
  2. Connect a test lamp between the listed LED dimming control circuit terminal and ground.
    • IP switchbank terminal 1 X1
    • 4wd mode switch terminal 4
    • Heated washer switch terminal 11
  3. Command the dimming test high to low with a scan tool. The test lamp should turn from bright to dim when changing between the commanded states.
    • If the test lamp is always off, test the control circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the BCM.
    • If the test lamp is always bright, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
  4. If all circuits test normal, test or replace the affected component.
scientia non olet · About LEMON Manuals