LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting >> Repair Instructions >> Parking and Turn Signal Lamp Replacement (SUT Rear) >> Installation Procedure

Installation Procedure

    Fig 1: Position Lamp Housing To End Cap
    GM1428250Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure the bottom edge is secured first.
  1. Position the lamp housing to the end cap opening.
  2. Press inward at the top of the lamp in order to secure the tab (3).
    3. Fig 2: Removing/Installing Lamp Bulb
    GM1428252Courtesy of GENERAL MOTORS CORP.
  3. Position the lamp socket (1) into the lamp (2) and turn 1/4 in order to secure.
scientia non olet · About LEMON Manuals