LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems And Power Management - Introduction (2 Of 3) >> Repair Instructions >> Ignition and Start Switch Replacement

Ignition and Start Switch Replacement

Fig 1: Ignition and Start Switch Replacement
GM1749570Courtesy of GENERAL MOTORS CORP.
Ignition and Start Switch Replacement

Callout Component Name

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  3. Remove the lower steering column trim cover. Refer to Steering Column Trim Covers Replacement .
1 Ignition/Start Switch Electrical Connector
2 Ignition/Start Switch Bolt (Qty: 2)
NOTE: Refer to Fastener Notice .

Tighten:  0.74 N.m (7 lb in)
3 Ignition/Start Switch
Procedure: 
Turn the ignition lock cylinder to the run position prior to removing the ignition/start switch.
scientia non olet · About LEMON Manuals