LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H3 Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Displays And Gages >> Diagnostic Information and Procedures >> Door Ajar Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connectors at the four door ajar switch assemblies.
  2. Ignition OFF, test for less than 1.0 ohm of resistance between each of the four ground circuits and ground.
    • If any of the ground circuits are greater than 1.0 ohm, test that ground circuit for an open/high resistance.
  3. Verify all the scan tool Door Ajar Switch parameters show Door Closed.
    • If not Door Closed, test the appropriate signal circuit for a short to ground. If the circuits test normal, replace the BCM.
  4. Install a 3-amp fused jumper one at a time between the four signal circuits and ground. Verify that each scan tool Door Ajar Switch parameter is Door Ajar when each signal circuit is jumpered.
    • If not Door Ajar, test the appropriate signal circuit for a short to voltage or an open/high resistance. If all circuits test normal, replace the BCM.
  5. Ignition OFF, reconnect the harness connectors at the four door ajar switch assemblies, one at a time. Open and close the door with the reconnected harness. Verify that each scan tool Door Ajar Switch parameter is Door Ajar when the door is open and Door Closed when the door is closed.
    • If not Door Ajar when open or Door Closed when closed, replace the appropriate door ajar switch assembly.
  6. If all circuits test normal, test or replace the IPC.
scientia non olet · About LEMON Manuals