Radio Front Floor Console Speaker Replacement

Radio Front Floor Console Speaker Replacement

Removal Procedure




1. Remove the center console from the vehicle.
2. Remove the instrument panel (I/P) compartment.
3. Remove the passengers I/P extension trim panel.
4. Remove the fasteners retaining the speaker housing to the body.




5. Partially remove the front speaker assembly from the I/P carrier.
6. Disconnect the electrical connector.




7. Remove the clips from front speaker assembly to expose speaker.

Installation Procedure






Notice: Refer to Fastener Notice.

Important: Do not exceed torque specification over tightening of the screws will result in the stud breaking from the front floor console.

1. Install the retainer clips to the speaker housing.

Tighten the screws to 9 N.m (80 lb in).




2. Install the front speaker assembly woofer to the I/P carrier.
3. Install the fasteners.

Tighten the screws 9 N.m (80 lb in).

4. Install the exterior trim panel.
5. Install the I/P compartment.