Rear Seat Replacement (Crew Cab with RPO A68)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Assembly & Nuts

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the rear center seat belt anchor nut. Refer to Seat Belt Replacement - Center Rear (Extended Cab) or Seat Belt Replacement - Center Rear (Crew Cab) .
1	Rear Seat Assembly Nut (Qty: 6) NOTE: Refer to Fastener Notice . Tip: Fold the rear seat cushion up to access the nuts. Tighten: 50 N.m (37 lb ft)
2	Rear Seat Assembly Tip: Split the rear seats if only one seat is to removed at a time. Refer to Rear Seat Separation (Extended Cab w/A68) . Lift the seat assembly upward to release the rear seat back hooks from the rear of the cab.