Manual Shift Shaft Seal Replacement

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Replacing Manual Shift Shaft Seal

Courtesy of GENERAL MOTORS CORP.

Callout	Component Procedure
1	Manual Shift Shaft Seal NOTE: Do not damage the case bore during removal of the manual shift shaft seal. NOTE: When installing the seal, ensure the seal lip is firmly seated against the case bore surface. Do not allow the seal lip to be crushed, or a leak may result. NOTE: Refer to Seal Reuse Notice . Special Tools DT 47770 Seal Installer. See Special Tools . J 45201 Cooler Line Seal Remover. See Special Tools .

Callout

Component Procedure

Manual Shift Shaft Seal

NOTE: Do not damage the case bore during removal of the manual shift shaft seal.

NOTE: When installing the seal, ensure the seal lip is firmly seated against the case bore surface. Do not allow the seal lip to be crushed, or a leak may result.

NOTE: Refer to Seal Reuse Notice .

Special Tools

DT 47770 Seal Installer. See Special Tools .
J 45201 Cooler Line Seal Remover. See Special Tools .