Fluid Pump Cover Cleaning and Inspection
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
CAUTION:
Valve springs can be tightly compressed. Use care when removing retainers and plugs. Personal injury could result. Preliminary Procedure: Clean and inspect all components and machined surfaces. |
|
| 1 | Pressure Regulator Valve Train |
| 2 | Converter Feed Limit Valve Train |
| 3 | Pressure Relief Ball Valve and Spring |
| 4 | TCC Control Valve and Spring |
| 5 | 1-2-3-4 and 3-5 Reverse Clutch Fluid Seal Rings (Qty: 3)
NOTE:
Do not use old seal rings. Install NEW seal rings. Reusing old seal rings may cause internal transmission leaks and transmission damage.
|
| 6 | A/Trans Fluid Pump Locator Pin |