LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1369 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Input and Output Speed Sensor Assembly Removal

Input and Output Speed Sensor Assembly Removal

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Cadillac Escalade EXT. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Input & Output Speed Sensor Assembly Components
GM1627571Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Removal

Callout Component Name
1 Bolt M6 x 20 (Qty: 2)
2 Speed Sensor Electrical Connector
Tip:  Release the connector lock before disconnecting.
3 A/Trans Input and Output Speed Sensor Assembly
4 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2)
Tip:  Inspect the clips and replace if damaged.
scientia non olet · About LEMON Manuals