LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1349 (Anti-Lock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rear Wheel Speed Sensor
    GM924313Courtesy of GENERAL MOTORS CORP.
  1. Using a twisting motion, install the wheel speed sensor until fully seated.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wheel speed sensor retaining bolt.

    Tighten:  Tighten the wheel speed sensor retaining bolt to 13 N.m (115 lb in).

  3. Connect the electrical connector.
  4. Install the wheel speed sensor wiring harness to the retainers.
  5. Lower the vehicle.
  6. Perform the Diagnostic System Check - Vehicle (without HP2) or Diagnostic System Check - Vehicle (with HP2) .
scientia non olet · About LEMON Manuals