Transmission Mount Replacement (2WD)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Transmission Mount, Crossmember Nut & Bolts (2WD)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Support the transmission with a transmission jack.
1	Transmission Mount to Crossmember Nut NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Transmission Mount Bolt (Qty: 2) Tighten: 50 N.m (37 lb ft)
3	Transmission Mount Tip: Raise the transmission with the transmission jack just enough to remove the transmission mount.