LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1159 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Disassemble >> Input and Output Speed Sensor Assembly Removal

Input and Output Speed Sensor Assembly Removal

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Input and Output Speed Sensor Assembly Component View
GM1627571Courtesy of GENERAL MOTORS CORP.
Input and Output Speed Sensor Assembly Removal

Callout Component Name
1 Bolt M6 x 20 (Qty: 2)
2 Speed Sensor Electrical Connector
Tip:  Release the connector lock before disconnecting.
3 A/Trans Input and Output Speed Sensor Assembly
4 A/Trans Input and Output Speed Sensor Wiring Harness Clip (Qty: 2)
Tip:  Inspect the clips and replace if damaged.
scientia non olet · About LEMON Manuals