LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1159 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Control Valve Body Assembly Assemble >> Control Solenoid Valve Assembly Installation

Control Solenoid Valve Assembly Installation

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Control Solenoid Valve Assembly Component View
GM1627736Courtesy of GENERAL MOTORS CORP.
Control Solenoid Valve Assembly Installation

Callout Component Name
1 Control Solenoid (w/Body and TCM) Valve Assembly
Tip:  Note the locator pin on the control valve lower body assembly while aligning the control solenoid valve assembly.
2 Bolt M5 x 53 (Qty: 2)
Tip:  Hand tighten only.
3 Bolt M5 x 55 (Qty: 4)
Tip:  Hand tighten only.
4 Bolt M5 x 45 (Qty: 5)
Tip:  Hand tighten only.
scientia non olet · About LEMON Manuals