Windshield Pillar Garnish Molding Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Windshield Pillar Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable the roof rail SIR system. Refer to SIR Disabling and Enabling . Remove the front assist handle, passenger side only. Refer to Front Assist Handle Replacement .
1	Windshield Side Garnish Molding Cover
2	Windshield Side Garnish Molding Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Windshield Side Garnish Molding Assembly Procedure Tabs must be installed prior to retainers. Tabs to be fully seated in I/P trim panel retainer and valance panel. Disconnect electrical connectors.
4	Windshield Side Garnish Molding Retainer (Qty: 2)