Center Pillar Upper Garnish Molding Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Center Pillar Upper Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove center pillar lower garnish molding. Refer to Center Pillar Lower Garnish Molding Replacement .
1	Center Pillar Upper Garnish Molding Cover
2	Center Pillar Upper Garnish Molding Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Center Pillar Upper Garnish Molding Assembly Tip: Remove seat belt D-ring from the adjuster assembly. Pull garnish molding toward inside of the vehicle to disengage the retainers. Align 4-way locator to center pillar before engaging retainers. Tighten: 35 N.m (25 lb ft)
4	Center Pillar Upper Garnish Molding Retainer (Qty: 4)