Front Seat Replacement - Bucket

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the front seat adjuster covers. Refer to Front Seat Adjuster Track Finish Cover Replacement . Disconnect the seat belt from the seat. Refer to Seat Belt Retractor Pretensioner Replacement - Front (Regular Cab) or Seat Belt Retractor Pretensioner Replacement - Front (Extended Cab) or Seat Belt Retractor Pretensioner Replacement - Front (Crew Cab) .
1	Front Seat Assembly Nut (Qty: 2) NOTE: Refer to Fastener Notice . Tip: Adjust the seat rearward to access to the nuts. Tighten: 45 N.m (33 lb ft)
2	Front Seat Assembly Bolt (Qty: 2) Tip: Adjust the seat forward to access the bolts. Tighten: 45 N.m (33 lb ft)
3	Front Seat Assembly Tip: Disconnect the electrical connector. If removing and installing seat the center seat or floor console do not need to be removed.