Front Seat Cushion Outer Trim Panel Replacement (Power)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Cushion Outer Trim Panel (Power)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Adjuster Outer Finish Cover Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Front Seat Adjuster Outer Finish Cover Procedure Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover. Pull outward to release the retainers from the seat assembly. Disconnect the electrical connectors. If replacing the finish cover, remove the switches and install on new finish cover.

Callout

Component Name

Front Seat Adjuster Outer Finish Cover Screw

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Front Seat Adjuster Outer Finish Cover

Procedure

Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
Pull outward to release the retainers from the seat assembly.
Disconnect the electrical connectors.
If replacing the finish cover, remove the switches and install on new finish cover.