LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1055 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Fluid Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Oil Level Indicator Tube & Transmission Seal
GM1869804Courtesy of GENERAL MOTORS COMPANY
NOTE: Lightly oil the seal to aid in the installation into the transmission case
  1. Install a seal (2) to the indicator tube.
  2. Install the oil level indicator tube (1) and seal (2) assembly.
  3. Lower rear of transmission to allow for clearance to install transmission oil level indicator tube into the transmission.
  4. Seat the oil level indicator tube seal into the transmission, then seat the oil level indicator tube.
  5. While holding the oil level indicator tube down into the transmission, Install transmission oil level indicator tube bracket nut. Tighten the nut to 22 N.m (16 lb ft).
  6. Install the exhaust heat shield to the transmission.
  7. Raise rear of transmission to install transmission crossmember.
  8. Install the transmission crossmember.
  9. Remove the jack.
  10. Lower the vehicle
    Fig 2: View Of Transmission Oil Level Indicator
    GM1284301Courtesy of GENERAL MOTORS COMPANY
  11. Install the transmission oil level indicator.
  12. Lock the transmission oil level indicator.
scientia non olet · About LEMON Manuals