LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1055 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Transmission Fluid Pan Installation (6L80)

Transmission Fluid Pan Installation (6L80)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Fluid Pan Assembly & Components
GM1696447Courtesy of GENERAL MOTORS CORP.
Transmission Fluid Pan Installation (6L80)

Callout Component Name
1 Fluid Pan Gasket
Tip:  The fluid pan gasket is reusable. Inspect the gasket to determine if it may be reused. If the gasket is stuck to the case or pan, it should be replaced.
2 Fluid Pan Assembly
3 Fluid Pan Bolts M6 x 20 (Qty: 18)
NOTE: Refer to Fastener Notice .

Procedure: 
Tighten in sequence shown.

Tighten:  9 N.m (80 lb in)