LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1055 (Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Instructions >> Output Carrier to Output Shaft Assemble (6L80/6L90)

Output Carrier to Output Shaft Assemble (6L80/6L90)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Output Carrier To Output Shaft Component View
GM1706884Courtesy of GENERAL MOTORS CORP.
Output Carrier to Output Shaft Assemble (6L80/6L90)

Callout Component Name
1 Output Carrier Thrust Bearing Assembly
2 Output Carrier Internal Front Gear
NOTE: Install the gear flat side down. Failure to install the gear flat side down may result in transmission damage.
3 Output Shaft Assembly
4 Output Carrier Internal Gear Retaining Ring
Tip:  Grasp the output shaft and carrier with both hands to turn over.
scientia non olet · About LEMON Manuals