LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 1054 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Instructions >> Transmission Mount Replacement (2WD)

Transmission Mount Replacement (2WD)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Transmission Mount (2WD)
GM1703322Courtesy of GENERAL MOTORS CORP.
Transmission Mount Replacement (2WD)

Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the transmission with a transmission jack.
1 Transmission Mount to Crossmember Nut
NOTE: Refer to Fastener Notice .

Tighten:  40 N.m (30 lb ft)
2 Transmission Mount Bolt (Qty: 2)

Tighten:  50 N.m (30 lb ft)
3 Transmission Mount
Tip:  Raise the transmission with the transmission jack just enough to remove the transmission mount.
scientia non olet · About LEMON Manuals