LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Reservoir Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing Reservoir Retaining Pins
    GM363760Courtesy of GENERAL MOTORS CORP.
  1. Apply the park brake and block the wheels.
  2. Remove the master cylinder. Refer to Master Cylinder Replacement .
  3. Drain the master cylinder reservoir.
  4. Secure the master cylinder in a vise. Do not clamp the master cylinder body, secure only at the flange.
  5. Remove the brake fluid level sensor by carefully depressing the retaining tabs and pushing the sensor through the reservoir.
  6. Carefully remove the reservoir retaining pins.
    7. Fig 2: View Of Master Cylinder Reservoir
    GM363761Courtesy of GENERAL MOTORS CORP.
  7. Remove the reservoir from the master cylinder by pulling the reservoir straight up and away from the cylinder.
  8. Remove the seals from the master cylinder.
scientia non olet · About LEMON Manuals