LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Pedal Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Brake Pedal Bolt & Nut
    GM375693Courtesy of GENERAL MOTORS CORP.
  1. Install the brake pedal.
  2. Install the brake pedal bolt.
    3. NOTE: Refer to Fastener Notice .
  3. Install the nut to the brake pedal bolt.

    Tighten:  Hold the nut with a wrench and tighten the brake pedal bolt to 47 N.m (35 lb ft).

    4. Fig 2: Brake Pedal Components
    GM793140Courtesy of GENERAL MOTORS CORP.
  4. Install the pushrod (3) and the stoplamp switch (2) to the brake pedal pin (1).
  5. Install the pushrod retaining clip (4).
scientia non olet · About LEMON Manuals