LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Midgate Hinge Replacement >> Removal Procedure

Removal Procedure

  1. Remove the midgate hinge covers. Refer to Midgate Hinge Finish Cover Replacement .
    2. Fig 1: View Of Midgate Components
    GM1427695Courtesy of GENERAL MOTORS CORP.
  2. Remove the lower center garnish molding (4). Refer to Endgate Center Molding Replacement .
  3. Disconnect the midgate harness electrical connector.
    4. Fig 2: Midgate Hinge Alignment Pin
    GM1486511Courtesy of GENERAL MOTORS CORP.
  4. Remove the nuts (1) securing the midgate hinge to the body.
  5. With the aid of an assistant, remove the midgate and place the midgate on a clean, protected surface.
  6. Remove the midgate inner panel. Refer to Midgate Inner Panel Replacement .
    7. Fig 3: Midgate Hinges
    GM1412514Courtesy of GENERAL MOTORS CORP.
  7. Remove the nuts securing the midgate hinge to the structure.
  8. Remove the hinge assembly from the midgate structure.
scientia non olet · About LEMON Manuals