LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Hood Latch Release Cable Replacement >> Removal Procedure

Removal Procedure

  1. Open the hood.
    2. Fig 1: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  2. Remove the cable end (1) from the latch.
  3. Release the retainer clips that retain the hood release cable to the cowl.
  4. Open the driver side door.
  5. Remove the driver side kick up panel. Refer to Front Floor Kick-Up Panel Replacement .
    6. Fig 2: Hood Release Handle Fastener
    GM833080Courtesy of GENERAL MOTORS CORP.
  6. Remove the fastener (1) retaining the hood release handle to the vehicle.
    7. Fig 3: Cable End & Hood Release Handle
    GM833078Courtesy of GENERAL MOTORS CORP.
  7. From the driver side compartment area, pull the cable through the access hole in the cowl (2).
scientia non olet · About LEMON Manuals