LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Fuel Tank Filler Pipe Housing Replacement (ND1) >> Removal Procedure

Removal Procedure

    Fig 1: Fuel Filler Cap
    GM1486509Courtesy of GENERAL MOTORS CORP.
  1. Open the fuel filler door.
  2. Remove the fuel filler cap in order to access the pocket screws.
  3. Remove the fuel pocket to filler neck screws.
  4. Remove the fuel filler pocket with door from the body side quarter panel.
  5. Remove the allen screws only if the gasket seal needs replacing.
scientia non olet · About LEMON Manuals