LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Wagon >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Bolted Exterior Body Panels And Closures >> Repair Instructions >> Folding Rear Panel Harness Replacement >> Removal Procedure

Removal Procedure

  1. Remove the midgate inner panel. Refer to Midgate Inner Panel Replacement .
    2. Fig 1: View Of Midgate Components
    GM1427695Courtesy of GENERAL MOTORS CORP.
  2. Remove the lower interior center molding (4). Refer to Endgate Center Molding Replacement .
  3. Remove the midgate window. Refer to Midgate Window Replacement .
  4. Remove the midgate window regulator. Refer to Midgate Window Regulator Replacement .
  5. Remove the midgate latches. Refer to Midgate Latch Replacement .
    6. Fig 2: Midgate Wiring Harness
    GM1412515Courtesy of GENERAL MOTORS CORP.
  6. Release the midgate wiring harness retainers from the midgate structure.
  7. Release the wire harness grommet from the midgate structure.
  8. Remove the midgate wiring harness from the midgate.
scientia non olet · About LEMON Manuals