LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> External Pages >> Different car >> Section 1719 (Antilock Brake System - Non-Hybrid Greater Than/Equal To 3900 Kg (8600 Lb) GVW With TCS & VES) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Wheel Speed Sensor
    GM2178528Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel speed sensor (1) to the rear axle.
    2. Fig 2: Identifying Rear Wheel Speed Sensor Bolt
    GM2178527Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the wheel speed sensor bolt (1) and tighten to 9 N.m (80 lb in).
    3. Fig 3: Identifying Rear Wheel Speed Sensor Electrical Connector & Harness Clips
    GM2178526Courtesy of GENERAL MOTORS CORP.
  3. Connect the wheel speed sensor electrical connector (1).
  4. Install the wheel speed sensor electrical connector and sensor harness clips (2) to the inboard frame rail.
  5. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals