LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Displays And Gages >> Repair Instructions >> Instrument Cluster Replacement >> Installation Procedure

Installation Procedure

    Fig 1: I/P Cluster Electrical Connections
    GM816329Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connections to the cluster.
  2. Position the I/P cluster to the instrument panel.
    3. Fig 2: I/P Cluster
    GM816330Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the screws to the instrument panel cluster.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    4. Fig 3: I/P Cluster Trim Panel Screws
    GM815927Courtesy of GENERAL MOTORS CORP.
  4. Install the instrument cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement .

    When the I/P cluster is replaced the new I/P cluster will need to be programmed. Refer to Instrument Cluster Programming and Setup .

scientia non olet · About LEMON Manuals