LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2007 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Displays And Gages >> Diagnostic Information and Procedures >> DTC P0462 >> Test Description

Test Description

The number below refers to the step number on the diagnostic table.

  1. 3:  Tests for the proper operation of the circuit in the high voltage range.
DTC P0462

Step Action Value(s) Yes No
Schematic Reference: Instrument Cluster Schematics 
1 Did you perform the Diagnostic System Check - Vehicle? - Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. With a scan tool, observe the Fuel Tank Level Remaining parameter in the powertrain control module (PCM) Enhanced evaporative emission (EVAP) data list.
Does the scan tool indicate that the Fuel Tank Level Remaining parameter is greater than the specified value?		 98% Go to Step 3  Go to Diagnostic Aids
3 
  1. Turn OFF the ignition.
  2. Disconnect C106.
  3. Turn ON the ignition, with the engine OFF.
  4. With a scan tool, observe the Fuel Tank Level Remaining parameter.
Does the scan tool indicate that the Fuel Tank Level Remaining parameter is less than the specified value?		 4% Go to Step 5  Go to Step 4 
4 Test the signal circuit of the fuel level sensor for a short to ground. Refer to Circuit Testing and to Wiring Repairs .
Did you find and correct the condition?		 - Go to Step 10  Go to Step 7 
5 Test the signal circuit of the fuel level sensor for a short to ground between C106 and the fuel level sensor. Refer to Circuit Testing and to Wiring Repairs .
Did you find and correct the condition?		 - Go to Step 10  Go to Step 6 
6 Inspect for poor connections at the harness connector of the fuel level sensor. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs .
Did you find and correct the condition?		 - Go to Step 10  Go to Step 8 
7 Inspect for poor connections at the harness connector of the PCM. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs .
Did you find and correct the condition?		 - Go to Step 10  Go to Step 9 
8 Replace the fuel level sensor. Refer to Fuel Level Sensor Replacement .
Did you complete the replacement?		 - Go to Step 10  -
9 Replace the PCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 - Go to Step 10  -
10
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 - Go to Step 2  System OK
scientia non olet · About LEMON Manuals