Marker Lamp Replacement - Rear Side (SUV)

MARKER LAMP REPLACEMENT - REAR SIDE (SUV)

REMOVAL PROCEDURE
1. Remove the interior trim panel.
2. Remove the wiring harness fastener from the body.




3. Disconnect the electrical connector.
4. Remove the screws from the lamp.
5. Remove the lamp, with the attached harness, from the vehicle.

INSTALLATION PROCEDURE
1. Install the lamp, with the attached harness, to the vehicle.




2. Install the screws to the lamp .

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (26 lb in).

3. Connect the electrical connector.
4. Install the wiring harness fastener to the body.
5. Install the interior trim panel.