Trim Plate Replacement - Instrument Panel (I/P) Accessory Right

TRIM PLATE REPLACEMENT - INSTRUMENT PANEL (I/P) ACCESSORY RIGHT

REMOVAL PROCEDURE




1. Remove the I/P (Instrument Panel) compartment.
2. Remove the I/P assist handle.
3. Remove the screws that hold the trim panel to the I/P.
4. Remove the trim from the tabs in the I/P.

INSTALLATION PROCEDURE




1. Align the trim pad with the I/P substrate tabs.
2. Install the trim panel screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 2 N.m (18 lb in).

3. Install the I/P compartment.
4. Install the I/P assist handle.