Instrument Panel Cluster (IPC) Replacement

INSTRUMENT PANEL CLUSTER (IPC) REPLACEMENT

REMOVAL PROCEDURE

IMPORTANT: The ignition switch must be in the OFF position when removing the instrument panel cluster.




1. Remove the I/P cluster trim plate from the instrument panel.
2. Remove the screws from the I/P cluster to instrument panel.




3. Remove the I/P cluster from the instrument panel.




4. Disconnect the I/P cluster electrical connections.

INSTALLATION PROCEDURE




1. Connect the electrical connections to the cluster.
2. Position the I/P cluster to the instrument panel.




3. Install the screws to the instrument panel cluster.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 2 N.m (18 lb in).




4. Install the instrument cluster trim plate.