LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions >> Transmission Fluid Filler Tube and Seal Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Oil Level Indicator Tube Nut
    GM396797Courtesy of GENERAL MOTORS CORP.
  1. Remove the transmission oil level indicator.
  2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right hand catalytic converter. Refer to Catalytic Converter Replacement in Engine Exhaust.
  4. Remove the transmission heat shield bolt and shield.
  5. Remove the nut securing the oil lever indicator tube to the transmission housing.
    6. Fig 2: View Of Oil Level Indicator Tube & Seal
    GM396798Courtesy of GENERAL MOTORS CORP.
  6. Place a drain pan under the vehicle.
  7. Remove the oil level indicator tube from the transmission case and seal.
  8. Remove the seal from the transmission case.
scientia non olet · About LEMON Manuals