LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions >> Tow/Haul Switch Replacement >> Removal Procedure

Removal Procedure

  1. Remove the instrument panel trim plate bezel. Refer to Instrument Panel Center Trim Panel Replacement in Instrument Panel, Gages, and Console.
    2. Fig 1: Transfer Case Control Switch Module
    GM815899Courtesy of GENERAL MOTORS CORP.
  2. Remove the switch receptacle screws.
    3. Fig 2: Switch Receptacle & Instrument Panel
    GM815900Courtesy of GENERAL MOTORS CORP.
  3. Pull the switch receptacle from the instrument panel and disconnect the electrical connectors from the switch.
    4. Fig 3: Removing/Installing Switch
    GM1527401Courtesy of GENERAL MOTORS CORP.
  4. Remove the switch from the receptacle.
scientia non olet · About LEMON Manuals