LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2006 >> H2 4D Utility Pickup >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 4L60-E/4L65-E/4L70-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions >> Tow/Haul Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Electronic Suspension Switch
    GM815943Courtesy of GENERAL MOTORS CORP.
  1. Install the switch to the receptacle.
    2. Fig 2: Removing/Installing Switch
    GM1527401Courtesy of GENERAL MOTORS CORP.
  2. Connect the electrical connector to the switch. Install the switch receptacle to the instrument panel.
    3. Fig 3: Transfer Case Control Switch Module
    GM815899Courtesy of GENERAL MOTORS CORP.
    NOTE: Fastener Notice in Cautions and Notices
  3. Install the switch receptacle screws.

    Tighten:  Tighten the screws to 12 N.m (106 lb in).

  4. Install the instrument panel trim plate bezel. Refer to Instrument Panel Center Trim Panel Replacement in Instrument Panel, Gages, and Console.
scientia non olet · About LEMON Manuals